Vulcan
We have seen Vulcan again inf our dreams, an he remmebered us that we haven't still finished the Retiario's Galerus.
We come back to work trying not to provoque his fury, in order to continue with his blessings.
We had achieve to make the form in the sheet of metal, and this was the final result.
Now we have to clean all the paint from the sheet of metal.
To do that, we use this brush an the drill.
(Dont forget to use gloves, because the brush slipping for the sheet of metal an we can get hurt)
After we remove all the paint this is the result.
Now we have the Galerus ready to fix on it the straps of fastening.
In our case we will use this old belts.
As you can see, we use 3 of them. the two of them at the top are to fix the galerus around the chest, in this case you could use only one but bigger. In our case, because we dont have a cinturon that big we use 2 differents belts, but with similar wide.
We will use the third belt in order to fix the galerus to the arm, a belt with lest wide will be enough.
Now we have to fabricate the fastenings of the belts to the sheet of metal. To do that, we cut with the drill that soak through a rectangles of metal the same shape of the belts that we are using.
Next, we turn the metal over a screwdriver for its central part.
With the help of our “anvil” and a small hammer, we turn the metal for one of it sides, in this way.
When the metal's pieces are turn, we insert the belt in the fastenings. (you will need to open the pieces a little bit with a screwdriver, and after that close them againg with a hammer).
Now, we read the measures that we need directly from the metal of the galerus, an we make the drills in order to rivet the fastenings (as we just did it with the Manicae)
When we just have the belt fasted, we will make the same operation with the others belts, an this is the result.
An we finish it. Now we just have to try it and adapt the long of the belts if they are too long.
¡¡Loor to Vulcan!!
No comments:
Post a Comment